 |
STORM PRO |
|
STORM PRO |
This is the building process of a GS-Racing STORM PRO with all pro's and con's found.
!Click on the pictures to enlarge!
STEP 44
 |
STEP 44 according to
the manual is the cutting of the body. But we do not! We first paint the body and then cut it. So we need paint (spray can, brush or airbrush) a knife and window cover tape. |
 |
The body comes with a blue transparent protective layer at the outside. DO NOT REMOVE THE PROTECTIVE LAYER! Take some fine sanding paper and rough all parts at the inside of the body only that need to be painted. The body becomes a little dull in color but that is OK. Do not touch the windows with the sanding paper. Rinse the body out with warm soap water and dry it with a paper towel. Cover all the windows or parts that may not be covered with paint and need to be clear at the end with covering tape. Apply this tape at the inside of the body. |
 |
I first looked at the decals and decided to make the
color scheme white with yellow. So I first took the yellow spray can and applied some thin layers. |
 |
Then I covered up the whole inside of the body with 5 thin layers of white. |
 |
Let the body dry one night. |
 |
Then peel off the blue protective layer. |
 |
The body with the protective layer almost off. |
 |
The left side of the body with out the protective layer. |
 |
The front side of the body with out the protective layer. |
 |
The right side of the body with out the protective layer. |
 |
Now take from the inside the window covering tape away and remove the glue residues if any are left behind. |
 |
The standard STORM decals |
 |
The special STORM PRO decals |
 |
Apply the decals on the places you like them, the picture shows some ideas. |
 |
Apply the decals on the places you like them, the picture shows some ideas. |
 |
Apply the decals on the places you like them, the picture shows some ideas. |
 |
Apply the decals on the places you like them, the picture shows some ideas. |
