Test and Reviews

X1-CR

Click on the pictures to enlarge

Step 13

	Take the 2.0 mm anti roll bar bar and place it in the slot.
	Take the two black plastic anti roll bar holders from the plastic tree.
	Fit the the black plastic anti roll bar holders with 3 x 8 mm round head hexagon screws using a 2 mm hexagon tool at the red marked spot. At the green marked spot fit 3 x 3 mm hexagon set screws using 1.5 mm hexagon tool. Adjust these 3 x 3 mm set screws so play is gone out of the anti roll bar but it can still move freely by its own weight.
	Take the readily prepared anti roll bar connector and slide it on the anti roll bar and tight the set screw using a 2 mm hexagon tool. Fit the bottom of the anti roll bar connector in the front lower suspension arm and fit at the red marked spot a 3 x 18 mm round head hexagon screw using a 2 mm hexagon tool.
	Anti roll bar ready
	No comment.
Comment by

BACK TO THE INDEX

This car is provided by

Taiwan