Test and Reviews

X1-CR

Click on the pictures to enlarge

Step 24

	Take the 4 x 73 mm lower inner hinge pin and fit a 3 mm E-clip in the groove. To prevent E-clips to get loose there is an option kit where the hinge pins are bolt/nut construction.
	Take the right hand side rear lower suspensions arm and fit it in-between the lower hinge pin holders. Slide the lower inner hinge pin from the front fully through.
	Secure this side of the lower inner hinge pin with a 3 mm E-clip.
	Perform the same steps for the left hand side and this is the result.
	No comment.
Comment by

BACK TO THE INDEX

This car is provided by

Taiwan