Test and Reviews X1-CR

This is the building process of a Hong Nor X1-CR with all pro's and con's found.

Click on the pictures to enlarge

Step 53

 picsstep53-002.jpg (68375 bytes)
Fit the rear shock absorber on the top shock ball and secure the it with a 3 x 6 mm washer and a 3 mm lock nut using a 5.5 mm wrench. 
Fit the shock shaft ball end in the lower rear suspension arm and place a 3 x 20 mm round head hexagon screw through the outer hole using a 2 mm hexagon tool. 
Perform the same steps for the left hand side. 
 picsstep53-003.jpg (61616 bytes) The car with all shock absorbers mounted viewed from the right hand side.
 picsstep53-004.jpg (60867 bytes) The car with all shock absorbers mounted viewed from the left hand side. 
 No comment.

Comment by

  

 

BACK TO THE INDEX

This car is provided by  Taiwan

 

© All rights reserved by