Test and Reviews

X1-CR

Click on the pictures to enlarge

Step 54

	All the parts needed for the standard dual stage air foam filter.
	Take the air filter connector and fit the short side to the air filter holder. Use a zip ty to secure them. Cut off the extended part of the zip ty using a sharp hobby knife.
	Take the inner air filter foam and put it in a plastic bag. The kit does not comes with air filter oil. We used R&B transparent RICINUS/METHANOL based air filter oil. You can use standard BLUE colored MotoCross based air filter oil too. Apply oil to the foam.
	Massage the oil thoroughly through the foam so it is evenly spread.
	Take a paper towel or an old T-shirt and massage all excessive oil from the foam filter.
	Slide the second stage foam air filter on the air filter holder and fit the end cap. Secure the end cap with 3 x 8 mm round head hexagon screw using a 2 mm hexagon tool.
	Now place the first stage air filter foam. In case of very dusty track conditions you can prepare this first stage air filter foam too with air filter oil.
	Fit the air filter connector to the neck of the carburator and use a zip ty at the red marked spot to secure it. Cut off the extended part of the zip ty using a sharp hobby knife.
	Nice the car comes with a dual stage foam air filter. Shame there is no air filter oil supplied.
Comment by

BACK TO THE INDEX

This car is provided by

Taiwan