Test and Reviews

X1-CR

Click on the pictures to enlarge

Step 56

	The kit comes with: 4 yellow colored dish rims using 17 mm wheel adapter 4 tyres Monza tyres  4 hard inserts.
	Make three slits in the center line of the carcass of the tyres using a sharp hobby knife or use a punch.
	Wear glasses during gluing tyres. Cyano Acrylic glue is dangerous when it hits your fingers eyes or other parts of the body. Take precautions to prevent any of this. Make sure the tyre edge is fitting in the outside groove of the rim. Place the tire on a flat surface. Force the side wall of the tire outwards by your finger and let a drop of Cyano Acrylic glue flow into the gap. Now slowly close the gap and let the tire side wall touch the rim. If there is to much glue it will come upwards be careful! In that case open the gap one centimeter beside the old spot and let the glue flow that way. Do this the whole tire around until the tire is fixed. By pulling on the tire wall after a few minutes you can check for the bonding. If there is a spot where the glue has not did his job, apply some more. Do not use excessive amount of Cyano glue. The less, the better the strength of the bonding. After 25 minutes check where the tyre is not attached to the rim and apply on these spots also a drop cyano acrylic glue. Repeat this sequence until the tyre is completely attached to the rim. Take your time to do this job!
	Then turn the outside of the tyre open. You might put some drops of cyano acrylic glue in the inside of the rim edge and tyre.
	Place the insert around the rim.
	Refit the tyre making sure the insert is not in between the rim and the tyre edge. Make sure the tyre edge is fitting in the outside groove of the rim.
	Wear glasses during gluing tyres. Cyano Acrylic glue is dangerous when it hits your fingers eyes or other parts of the body. Take precautions to prevent any of this. Make sure the tyre edge is fitting in the outside groove of the rim. Place the tire on a flat surface. Force the side wall of the tire outwards by your finger and let a drop of Cyano Acrylic glue flow into the gap. Now slowly close the gap and let the tire side wall touch the rim. If there is to much glue it will come upwards be careful! In that case open the gap one centimeter beside the old spot and let the glue flow that way. Do this the whole tire around until the tire is fixed. By pulling on the tire wall after a few minutes you can check for the bonding. If there is a spot where the glue has not did his job, apply some more. Do not use excessive amount of Cyano glue. The less, the better the strength of the bonding. After 25 minutes check where the tyre is not attached to the rim and apply on these spots also a drop cyano acrylic glue. Repeat this sequence until the tyre is completely attached to the rim. Take your time to do this job!
	One rim ready. Watch the rotation of the tyre surface and make two pairs of equal rotation direction.
	The rims ready.
	Nice tyres and inserts are included.
Comment by

BACK TO THE INDEX

This car is provided by

Taiwan