Test and Reviews X1-CR

This is the building process of a Hong Nor X1-CR with all pro's and con's found.

Click on the pictures to enlarge

Step 58

 picsstep58-001.jpg (39738 bytes) Drill two 7 mm holes at a 24 mm distance from the center line using a 7 mm drill bit or a reamer.
The rear side of the wing has markings to easy up the measurement.
 picsstep58-002.jpg (50668 bytes) Fit at the red marked spots a 3 mm lock nut.
 picsstep58-003.jpg (53536 bytes) Mount the wing to the wing stands and place the black plastic washers on top.
Then fit 3 x 12 mm round head hexagon screws using a 2 mm hexagon tool at the red marked spots. 
 Shame the wing is not pre drilled.

Comment by

  

 

BACK TO THE INDEX

This car is provided by  Taiwan

 

© All rights reserved by